Slotket ID and jumper settings? \ VOGONS

Slotket ID and jumper settings?

Topic actions

First post, by oh2ftu

Posted on 2024-05-14, 11:11

oh2ftu Offline

Rank Member

Rank: Member
Posts: 179
Joined: 2023-06-21, 09:10
Location: Finland

Hi,
I have this very generic looking slotket I'm about to use.
What I do know, is that coppermine is NOT supported.
Any idea what that lonely jumper does?

Reply 1 of 2, by oh2ftu

Posted on 2024-05-14, 12:04

oh2ftu Offline

Rank Member

Rank: Member
Posts: 179
Joined: 2023-06-21, 09:10
Location: Finland

Aah. I did some pinout-tracing.
It goes to B21 and is 100/66MHz(?). JP1 middle.
So seems quite redundant and will not break anything

Reply 2 of 2, by PARKE

Posted on 2024-05-14, 13:00

PARKE Offline

Rank Oldbie

Rank: Oldbie
Posts: 1199
Joined: 2015-07-31, 12:46

At some point is was marketed/branded as "Matrix". It derives from a model developed by the japanese Kikumaru's Technical Laboratory.

The attachment Matrix.jpg is no longer available

Go to top of page Go to top of page

Back to General Old Hardware