-5V support pcb ISA ? \ VOGONS

-5V support pcb ISA ?

Topic actions

First post, by Jackhead

Posted on 2024-08-24, 08:55

Jackhead Offline

Rank Oldbie

Rank: Oldbie
Posts: 536
Joined: 2020-04-15, 12:10
Location: Germany

I need -5V for a ISA Soundcard.
My problem is, im not a big friend using 30+ years old PSUs on my expensive retro hardware.
So i come up with this little adapter PCBs that you plug into a ISA slot to get transformed -5V to the ISA bus.

The attachment s-l1600.jpg is no longer available

Anyone use this kind of pcb?
How exactly did they work? Any risks?
How they work if you also have VLB slots?

Dos 6.22: Asus VL/I-486SV2GX4 Rev 2.0 1Mb L2 - A5x86 X5 P75 - 64MB - AHA-2842A VLB - ET4000W32P VLB - CT2230 - GUS ACE - MPU-401AT with YucatanFX
Win98SE: Asus P5K-WS - E8600 @ 4,5GHz - Strange God Voodoo 5 6000 PCI-X - 2GB DDR2 1066 - Audigy 2 ZS

Reply 1 of 2, by Grzyb

Posted on 2024-08-24, 08:59

Grzyb Offline

Rank l33t

Rank: l33t
Posts: 2674
Joined: 2019-05-08, 13:47
Location: CET-1CEST-2

Search for "Voltage Blaster"...
https://www.philscomputerlab.com/voltage-blaster--5v.html

Nie rzucim ziemi, skąd nasz root!

Reply 2 of 2, by mkarcher

Posted on 2024-08-24, 10:09

mkarcher Offline

Rank l33t

Rank: l33t
Posts: 3627
Joined: 2019-01-19, 16:29
Location: Germany

Jackhead wrote on 2024-08-24, 08:55:

How exactly did they work? Any risks?

They take the -12V on the ISA bus and use a voltage regulator that passes some current from the -12V pin into the -5V pin, in a way that at the -5V pin there is just -5V. The remaining 7 volts are converted to heat in the regulator. Think of the regulator as a self-adjusting resistor that removes the excess voltage so just -5V remains.

The 7905 regulator is quite robust. It has short circuit protection and over-temperature protection, so the risk of that chip breaking and passing -12V directly to the -5V line is very low. As long as the power supply does not connect to the -5V line on the mainboard, this PCB is the only source of -5V, so there is no conflict which might damage a second -5V source.

Jackhead wrote on 2024-08-24, 08:55:

How they work if you also have VLB slots?

There is no -5V connected to the VLB part of VLB/ISA slots, so you need to extra hardware to make sure that -5V is injected into the VLB part as well. This adapter hangs over towards the rear of the computer, so it will also fit an ISA/VL combination slot.

Go to top of page Go to top of page

Back to General Old Hardware