Hi guys, hope your all doing good.

I'm currently repairing two Voodoo 2's. Got them both to the state of being recognised in DOS (Detect and Mojo) and windows device manager.

I am seeing cards being identified and all 12mb of memory. Both TMU's are also showing up, but the system is crashing when launching 3dmark.

I'm looking to use the debug mode (through Autoexec.bat) but I'm getting no output (using console output switch). Does anyone know of a good tutorial to get it working? I've put all the commands in Autoexec, but realise I must be missing a vital step(s). I'm just being stupid I'm sure. Been a long time since I've delved this deep into DOS/Windows 98!

Do I need anything else loading on boot for the debug mode to see the card?

Cheers guys

Mark