VOGONS


First post, by zwrr

User metadata
Rank Member
Rank
Member

I came across someone selling a circuit board—specifically the model YAMAHA XU105 XG shown in the picture. I noticed that the chips on it are identical to those found on the DB50XG WaveBlaster card, and the board includes the complete DAC and op-amp circuitry. Does this mean it might be possible to modify it into a WaveBlaster card?

The attachment XU105-1.jpg is no longer available

SBC1: Cyrix 5x86-120, HS-5x86HVGA, 16MB EDO, GD54M30, SB Pro II, HardMPU-wt
SBC2: VIA C3-800, PCISA-C800, 128MB SDRAM, Savage4 Pro, SB AWE64 Gold
SBC3: Tualatin-S 1.4G, PCI-6872, 256MB SDRAM, FX5200 PCI, Voodoo2 SLI, SB Live

Reply 1 of 1, by Tiido

User metadata
Rank l33t
Rank
l33t

It should be relatively simple. On the H8/3002 chip (the CPU) Pin 16 or 17 is the MIDI UART signal input, pin 65 is the reset signal. Audio outputs and power supplies should be easy to figure out too. I'd like to see a photo of the rear side of the board.

T-04YBSC, a new YMF71x based sound card & Official VOGONS thread about it
Newly made 4MB 60ns 30pin SIMMs ~
mida sa loed ? nagunii aru ei saa 😜