You don't need to change the BIOS to use it as an IDE card - use one drive and set it as the array and it will work fine. There will be a slight increase in boot time as the card's BIOS screen comes up and it detects the drive, but that's more than made up for with the increase in drive speed over …

Hey does anyone know what bios is needed to be able to flash a Promise FastTrak 100 TX2 into like the Ultra series? I just want to use it as an IDE card not a raid card but all posts I can find are people doing the opposite. Promise Still have the bios available but I dont know what ones to flash.

Thats the ticket! Thanks team.

I need help from the brain trust trying to get this XP rig working. I have run out of ideas and keep getting this same bluescreen. The internet says its memory related BUT I have run Memtest for like 15hrs straight with zero issues. Is there a bios setting causing this? System Specs Windows XP 32bit …

I will check the mosfets and AMS1117 and see what happens. Steps to Repair Radeon 9600 First, check the integrity of the GPU crystal, especially at the corners. Secondly - core power. 1.2-1.3V and memory 2.5-3.0V (depending on design. Memory can be powered by one or two identical regulators - Mem_ …

pins 2 and 3 on side B are shorted to ground. Its side "A" - AGP detect +5V rail - on other side. Its connect to small electrolitic near AGP slot and traced via ferrite bead B17 to big capacitor C301 and Mosfeet. Fuse F1 - its powering DDС in monitor. Its must be AMS1117/LM7805, but its cheap …

Hey Team, I am having a tough time figuring out what is wrong with the Radeon R9600 Pro AGP GPU. The PC locks up and won't post with it plugged in ( verified the PC works with another card ). Going through the 1.5V AGP pinout it seems pins 2 and 3 on side B are shorted to ground. Does anyone have …

So I tried to get a hold of alexanrs here on vogons but I've had no reply and he hasn't been on in 2 years, so I've given KiCAD a go to re-create his design to the best of my ability without just copying it. Here's what I've managed, if anyone with PCB CAD knowledge could proof it for me that would …

@deksor, I will get a good photo of the boards for you. I measured the crystal and it is putting out the correct frequency ( measured at the crystal ). Is there somewhere else I should be measuring it? @waterbeesje, I have two of these boards and configured them both exactly the same. One worked and …

Hey Team, first post here. I have two boards of which I am trying to get one of them going. I have tested all the parts separately so I know its just the boards ( tested PSU, ram, cpu, vga card, cache, bios on one of them in working unit ) I have two of the MB-4DUVC boards ( the UMC chipset one ) …

I'm aware this is a super old thread but there was nobody else that had this board. Does the OP have the Bios for this board? I have the same board and am struggling to find it and get the board booting at all.