For Orpheus I, when using OPL3 the volume is always maximum regardless of the mixer setting. This issue will be gone for Orpheus II?

So I took a look at the 72-pin connector I had on there, and it was #1 Out of stock and #2 tin pins. That has been corrected to gold pins and just our luck, in (low) stock. Edit: I see that many of the Panasonic resistors are not in stock as well. Any suggestions on replacements of the same or …

[...]The volume of SFX cannot be adjusted. I set the volume for both orphinit and unisound but it seems that the SFX volume is always maximum regardless of the volume setting in the setup.exe or orphinit or unisound. OK there is a workaround for this - tested with the LG version - 1st step is to …

I cannot hear CD-audio music when I play "The Eye of Typhoon" where it requires "Perfect SB-Pro support" on its manual. [...] Thanks to ripsaw8080's help it is found that the game writes some undocumented/unknown SB registers on startup . No idea why this is though - could be their dev soundcard …

Marmes wrote on 2022-05-29, 11:23: Can you try to use wss instead of SB? Thanks,! I tried wss mode remaining other parameters the same. It doesn't work either.

Hello, Could you be more specific? What are you using to initialize the card? Orphinit or unisound? Could you post your orpheus.ini if using orphinit, or commands in unisound? Thanks! I used orphinit and as I remember using unisound doesn't help. Here is my orpheus.ini …

I cannot hear CD-audio music when I play "The Eye of Typhoon" where it requires "Perfect SB-Pro support" on its manual. Other games using CD-audio music works fine. I tested other cards with this game like Yamaha YMF724 and SB Live! and for these cards CD-audio works fine. I don't know what's the …

'Wonderland' and 'A-10 Tank Killer' (pre-v1.5) are now freed from IRQ 2. Finally, all games having footnote (2) in the compatibility list for v1.91 are dealt with. Check out in https://kykypyza.tistory.com/category/MS-DOS/Game%20mod

'Innocent Until Caught' is now freed from IRQ=2. The original Roland driver 'IUC_RLND.DRV ' uses fixed IRQ number 2. I modified the hex to assign IRQ 5, 6, 7 , 10 or 11 (port 330h). https://kykypyza.tistory.com/9 Tested with IRQ 7. thanks for sharing these! I will link your site to the PCMIDI page …

'Innocent Until Caught' is now freed from IRQ=2. The original Roland driver 'IUC_RLND.DRV ' uses fixed IRQ number 2. I modified the hex to assign IRQ 5, 6, 7, 10 or 11 (port 330h). https://kykypyza.tistory.com/9 Tested with IRQ 7.

Princess Maker 1 (Japanese) and Princess Maker 2 are now liberated from fixed IRQ=9 . I found where the IRQ number is inputted as constant 9 (it was just 9, not 2 or 9) and modified hex from corresponding executables. For Princess Maker 1 (Japanese) it is AUTOEXEC.EXE and for Princess Maker 2 it is …