That's an inductor, not resistor. Power goes through it, so unless it's feeding some external connector, it's a required component. Ah right, I'm completely clueless when it comes to PCBs and components. I found another Vogon thread with the same issue https://www.vogons.org/viewtopic.php?p=1042044 …

A small black rectangle (SMD?) resistor marked with 150k fell of the back of my Voodoo 3 3500, is it screwed? -edit- In one system, it wont post. There's 1 long beep 2 short beeps and no display . In another system it seems to post and run just fine. Which resistor is it? Pictures are always …

A small black rectangle inductor marked with 150k fell of the back of my Voodoo 3 3500, is it screwed? -edit- In one system (440bx), it wont post. There's 1 long beep 2 short beeps and no display . In another system (i815) it seems to post and run just fine.

You should have no problem at all. 24p atx s still 24p atx. The only thing you may miss is a -5v line if that wire is absent (and no longer required by modern ATX standard). As for the front panel: I think you want to use an older ATX board with a more modern case? LEDs still have the same voltage …

Apologies if this is a dumb question, but is it safe to use modern extension cables for 24pin and front panel connectors with old hardware?

That sounds like something actually failed in the monitor and further use of it is possibly disasterous. I'm not quite sure what has failed but it is in line deflection area, and most likely some high voltage capacitor in there failed which can produce the geometry distortion observed. Figured as …

Hey all. After changing a monitors color depth to 24bit, the monitor freaked out and now it's stuck in permanent overscan with screwed geometry (noticably on the right side). Also changing the resolution to anything above 800x600 causes it to switch off. Recall button does nothing. I attached …