registers over 100h are readed as 0 Yes, if you read them one byte at a time, you get 0. You need to read them as 32-bit long words. 16-bit might work, but that dump is using 32-bit reads. From offset 0x168 there are no registers that I know of, so the last 8 bytes of the dump are just random junk. …

Btw from where ysbemu.exe came from? Never heard about it yet. Some fork/mod of sbemu? I made an SBEMU driver for YMF7xx cards. It should be merged into crazii's main version on github soon. For this ysbemu, it is just SBEMU with most parts disabled. The source is here: https://github.com/ …

just no sound at all. the output when using ymf7xx.exe /e shows that the volume levels are 0 - is this normal? do I still need a mixer to unmute the sources? If you run the attached ysbemu.exe, it should unmute pretty much everything and enable S/PDIF output, with the copyright bit set to OFF. You …

I made some improvements: (1) Now the S/PDIF status bits are set correctly. The copyright bit is set to OFF, so you should not have any trouble recording. (2) Enabled the ADC for the analog inputs. (3) Unmuted Mic, Video, and Aux analog inputs. On my card, Mic, CD, Video, and Aux all get mixed into …

Analog Line-out works now, and you can use /MCOM9 to not use a serial port.

Would it be possible to implement port remapping for real OPL and MPU-401 interfaces like RemapCMI does? Yes, I got it working with a YMF744. It probably isn't possible with a 724. Try the attached SBEMU.EXE (for YMF744/YMF754 only) You should try a lower volume than usual, since the volume setting …

I added protected mode MPU-401 UART support to SBEMU, see SBEMU with protected mode MPU401 UART support You can still use SoftMPU on a different port, for Intelligent Mode.

It outputs MIDI data to a serial port, which you can connect to your Roland/Yamaha/... devices. EXE file attached, source is here: https://github.com/jiyunomegami/SBEMU Tested with JEMM, QPIEMU ,and HDMPI32I. Intelligent mode is not supported, but you can use SoftMPU for that, on different port. …

The same system also works great with a more modern motherboard: Asus B75M-PLUS w/1GB of DDR3 RAM and no PCI/PCIE cards at all. It has pin headers for one COM port and one LPT port on board, and there are working drivers for the NIC (RTL8168) for use with mtcp. A bit off topic, but Cloudschatze's …

Monkey Island I & II work just fine! Thanks! My setup here is sort of odd, but I don't see why it wouldn't work with a normal serial port and sound card. hw: emachines 1300 nForce 430 AM2/Athlon64 Intel HDA Moschip serial/parallel port low profile PCI-Express card COM1 connected to Roland SK-50 ( …