VOGONS

Search

Common searches

Search results

Display options

Display options

Re: ISA IDE CARD SETUP

Posted on 2023-03-28, 19:09

I see in your autoexec.bat that you typed LH C:\CDROM\SHSUCDEX D:CDROM /M:15 /E /S /L:D /V Shouldn't it be LH C:\CDROM\SHSUCDEX / D:CDROM /M:15 /E /S /L:D /V ? You could also try to simplify it (for testing) to just C:\CDROM\SHSUCDX /D:CDROM /L:D All is now good and I want to say thanks to all. I …

Re: ISA IDE CARD SETUP

Posted on 2023-03-28, 16:23

Is that isa card jumpered correctly of IRQ 15? It does not look like that. It should be one more away from the slot bracket. My bad as I overlooked that. Ok I set to irq of 15 on the jumpers for this card and the drive is now detected BUT I'm struggling with identifying the drive letter for the …

Re: ISA IDE CARD SETUP

Posted on 2023-03-28, 13:25

Well, what 486 board and what IDE controller do you use for the hard disk ? I guess your mainboard or the controller where you have connected the hard disk to has dual channel. Thus your ISA controller and the present hardware is in conflict then. Then you either need to remove that ISA controller …

Re: ISA IDE CARD SETUP

Posted on 2023-03-28, 12:32

No, it does not require drivers. Simple IDE controllers like this do little more than attach your IDE device to the ISA bus. It is likely jumpered to be a secondary controller so you probably can’t boot from it with most standard BIOS without changing the jumpers. The CDRom audio is just a …

ISA IDE CARD SETUP

Posted on 2023-03-28, 11:32

So recently gone right back to the family 486 where it all started for me. I've had to set the system up again using the original recovery media but this ISA IDE card baffles me. When the CDROM driver is attempting to load on startup I'm getting the error that no CD-ROM drive is connected. This is …

Page 1 of 4

Go to top of page Go to top of page
Close window
Close window