I would like to be able to have a batch file that will run a particular program when I start DosBox. Is that possible? Please address you responses to a newbe without much technical skill.
Thank you very much,
Michael
Michael Perelman
Economics Department
California State University
Chico, CA
95929
530 898 5321
fax 530 898 5901
http://michaelperelman.wordpress.com
Autoexec part of the dosbox config
wrote:Autoexec part of the dosbox config
Thank you. I cannot access the file in Windows 7. I can see the relevant folder: dosbox-0.74.conf, but I cannot access the file. I know how to format the commands I need to mount the drives and to start the program I need when I put them in manually. How can I get them into the authoexec.
Any help will be appreciated.
Michael Perelman
Economics Department
California State University
Chico, CA
95929
530 898 5321
fax 530 898 5901
http://michaelperelman.wordpress.com
There should be a link in the start menu under the DosBox folder that reads "Options" inside that sub-folder there should be a link that reads: "DosBox 0.74 Options" that will allow you to edit the file. Otherwise, the file is located at
"C:\Users\<youruser>\AppData\Local\DOSBox\dosbox-0.74.conf"
