First post, by V15UAL K3YS
Hey, I have a Logitech G920 racing wheel and am trying to get it to work in NFSSE with Dosbox. I have it detected as a 4-Axis Wheel (4axis in .conf file) and DOSBox recognizes the wheel and maps it appropriately. In NFSSE, I have run the JCU.exe file to configure the game to run with the wheel and used the Generic Racing Wheel configuration, enabling all buttons and axis. However, when I start the game, the controls go out of whack and the game acts like it is cycling through the selections on its own at random rates, making it nearly impossible to simply navigate the menu screen. Holding the wheel to the side far enough will get it to stop going up and down but then it will automatically cycle left or right, and I can't make selections this way. I even disconnected the wheel while the game was running and it was still acting the exact same way, even with the wheel disconnected.
If you have any suggestions or anything I could do to fix it, that would be great.