by psyklik » 2019-8-05 @ 11:46
Looking forward to some assistance in getting the serial ports working in DOSBox.
I have set up the DOSBox config for serial ports as instructed with the following.
serial1=directserial: realport:COM1
serial2=directserial: realport:COM2
Yet, I get the following message upon running DOSBOX for both instructions.
"directserial:" is not a valid value for varible: type.
I am working version 0.74-3
Please review attached screenshot.
Any help will be greatly appreciated,
You do not have the required permissions to view the files attached to this post.