VOGONS

Is the ASUS CUSL2 Rev. 1.02 any good?

Topic actions

First post, by assortedkingdede

Posted on 
User metadata
Rank Newbie
Rank
Newbie

I was going to replace my P6BAP-A+ motherboard due to limitations with it (I'll likely reuse it for DOS stuff) and I was looking at getting an ASUS CUSL2 Rev. 1.02 due to its AGP compatibility so I could get a much better GPU than the GeForce MX 200 I currently have. Is this motherboard any good?

Reply 1 of 3, by pentiumspeed

Posted on 
User metadata
Rank l33t
Rank
l33t

Supports up to Coppermine CPUs, up to 1GHz with reasonable processor prices.

AGP slot is universal 4x and 2x and 1.5V, not sure on 3.3V part.

The southbridge supports ATA 133. But not suitable for native DOS sound due to no 5 pin interface for the sound card to enable DOS support.

Cheers,

Great Northern aka Canada.

Reply 2 of 3, by assortedkingdede

Posted on 
User metadata
Rank Newbie
Rank
Newbie
pentiumspeed wrote on 2022-12-28, 01:58:
Supports up to Coppermine CPUs, up to 1GHz with reasonable processor prices. […]
Show full quote

Supports up to Coppermine CPUs, up to 1GHz with reasonable processor prices.

AGP slot is universal 4x and 2x and 1.5V, not sure on 3.3V part.

The southbridge supports ATA 133. But not suitable for native DOS sound due to no 5 pin interface for the sound card to enable DOS support.

Cheers,

Should support both voltages, the manual says that the left 20 pin section is covered by default to prevent a card that doesn't use the whole slot from getting moved around.

Go to top of page Go to top of page
Back to General Old Hardware
Close window
Close window