VOGONS

[386] Checksum error at post

Topic actions

First post, by 386SX

Posted on 
User metadata
Rank l33t
Rank
l33t

Hi,

I've changed the battery of my Soyo SY-019I Eteq based motherboard and it's ok, battery is operational and everything but sometimes when I left it too much without powering up it shows at post the "Checksum error press F1" error loosing all the previous bios config. Does it mean that something is wrong with the battery? I used the usual three-cell Ni-Mh 3.6 80Mah battery you can find in eletronic stores and soldered wires on the mobo.
Before it gave me the battery error cause obviously it was gone. It happens sometimes without a certain reason. The only logic is the time I left it without power.

Thank.

Reply 2 of 5, by 386SX

Posted on 
User metadata
Rank l33t
Rank
l33t
Scali wrote:

Yes. The BIOS calculates a checksum value for the current configuration in the CMOS. If it sees a mismatch, the data is corrupt. Which means the battery hasn't done its job of powering the CMOS when the system was turned off.

But the battery I use it's new. And the second I tried so what could it be? Bad soldering? Usually it works if I switch it off and on even after hours but if I left it too much often it gave me this error.

Reply 4 of 5, by 8086-ProGamer

Posted on 
User metadata
Rank Newbie
Rank
Newbie

Try to find if the connection is bad, by using a multimeter and connect it to another point by following the traces

Reply 5 of 5, by 386SX

Posted on 
User metadata
Rank l33t
Rank
l33t

well i changed again the battery and connected it without wires but directly. Lets see if it does it again, i will update tomorrow. 😀

Go to top of page Go to top of page
Back to General Old Hardware
Close window
Close window