This AMD 386 board with no liquid damage. (thanks to GS Saft "Sealed NiCd battery")
1Standby Mode (Am386SXL/SXLV Only) 2The true static design of the Am386SXL/SXLV micro- 3processor allows for a Standby Mode. At any operating 4speed, the microprocessor will retain its state (i.e., the 5contents of all its registers). By shutting off the clock 6completely, the device enters Standby Mode. Since 7power consumption is proportional to clock frequency, 8operating power consumption is reduced as the fre- 9quency is lowered. In Standby Mode, typical current 10draw is reduced to less than 20 microamps at DC. Not 11only does this feature save battery life, but it also sim- 12plifies the design of power-conscious portable applica- 13tions in the following ways.
Runs great, without any problems. I love that purple pcb.
I bought a brand new Geforce4 heatsink off Ebay some time ago and it only felt right to give it to this one. It almost looks brand new now.
The ti4800SE is just missing that unique heasink. Seems to be in good condition.
I finally found a Voodoo4. In theory, it still may be repairable. The pcb is intact with no broken traces. However I'm not skilled enough to ball solder a new VSA100, let alone have the tools. If nothing else, I could use it to repair any Voodoo4s I may come across in the future.
Now here's something interesting. A Nvidia NV1, which is unfortunately missing its eprom.
I didn't see any memory expansion modules at the ewaste site.
I already ordered a Sega Saturn controller breakout card off Ebay. https://www.ebay.com/itm/324735975372?h ... w6Z5g8NeS I don't have any of the cables that I need for it though.
Aublakwrote on 2021-11-09, 14:00:IMG_20211109_075008.jpg
The SB2.0 is missing its OPL chip. I don't have any spares, but one of my other cards can loan it for te […] Show full quote
IMG_20211109_075008.jpg
The SB2.0 is missing its OPL chip. I don't have any spares, but one of my other cards can loan it for testing.
This Tseng card seems perfect for my 386 build.
IMG_20211109_092210.jpg
Its missing its eprom. Not sure what chipset its using.
IMG_20211109_075034.jpg
Now here's something interesting. A Nvidia NV1, which is unfortunately missing its eprom.
I didn't see any memory expansion modules at the ewaste site.
I already ordered a Sega Saturn controller breakout card off Ebay. https://www.ebay.com/itm/324735975372?h ... w6Z5g8NeS I don't have any of the cables that I need for it though.
IMG_20211109_075100.jpg
What part of Ohio are you finding all this vintage ewaste?
Collector of old computers, hardware, and software
Aublakwrote on 2021-11-09, 14:00:IMG_20211109_075008.jpg
The SB2.0 is missing its OPL chip. I don't have any spares, but one of my other cards can loan it for te […] Show full quote
IMG_20211109_075008.jpg
The SB2.0 is missing its OPL chip. I don't have any spares, but one of my other cards can loan it for testing.
This Tseng card seems perfect for my 386 build.
IMG_20211109_092210.jpg
Its missing its eprom. Not sure what chipset its using.
IMG_20211109_075034.jpg
Now here's something interesting. A Nvidia NV1, which is unfortunately missing its eprom.
I didn't see any memory expansion modules at the ewaste site.
I already ordered a Sega Saturn controller breakout card off Ebay. https://www.ebay.com/itm/324735975372?h ... w6Z5g8NeS I don't have any of the cables that I need for it though.
IMG_20211109_075100.jpg
What part of Ohio are you finding all this vintage ewaste?
Collector of old computers, hardware, and software
Law212wrote on 2021-11-09, 18:39:Found this bad boy the other day. Whats a good way to clean it up?
https://i.imgur.com/MKLzPPU.jpg
https://i.imgur.com/GbXD2iH. […] Show full quote
Found this bad boy the other day. Whats a good way to clean it up?
Just plain old dish wash liquid and hot water with a cotten rag will be fine for the most part. Just be care around the top vent. Using a few cotten buds for them i'd say.
There's a glitch in the matrix.
A founding member of the 286 appreciation society.
Apparently 32-bit is dead and nobody likes P4s. Of course, as always, I'm open to correction...😉
Just plain old dish wash liquid and hot water with a cotten rag will be fine for the most part. Just be care around the top vent. Using a few cotten buds for them i'd say.
Thanks!
Last edited by Stiletto on 2021-11-11, 19:43. Edited 1 time in total.
Aublakwrote on 2021-11-09, 14:00:IMG_20211109_075008.jpg
The SB2.0 is missing its OPL chip. I don't have any spares, but one of my other cards can loan it for te […] Show full quote
IMG_20211109_075008.jpg
The SB2.0 is missing its OPL chip. I don't have any spares, but one of my other cards can loan it for testing.
This Tseng card seems perfect for my 386 build.
IMG_20211109_092210.jpg
Its missing its eprom. Not sure what chipset its using.
IMG_20211109_075034.jpg
Now here's something interesting. A Nvidia NV1, which is unfortunately missing its eprom.
I didn't see any memory expansion modules at the ewaste site.
I already ordered a Sega Saturn controller breakout card off Ebay. https://www.ebay.com/itm/324735975372?h ... w6Z5g8NeS I don't have any of the cables that I need for it though.
IMG_20211109_075100.jpg
What part of Ohio are you finding all this vintage ewaste?
Just plain old dish wash liquid and hot water with a cotten rag will be fine for the most part. Just be care around the top vent. Using a few cotten buds for them i'd say.
Thanks!
You are most welcome.
Last edited by Stiletto on 2021-11-11, 19:44. Edited 1 time in total.
There's a glitch in the matrix.
A founding member of the 286 appreciation society.
Apparently 32-bit is dead and nobody likes P4s. Of course, as always, I'm open to correction...😉