First post, by infiniteclouds
I'd like to move my new Slot 1 build into the an XPS case -- but I have to do something about getting the front panel connector connected to non-Dell motherboard.
plugs into here on the Dell motherboard:
I've figured out easily enough which of the sockets in picture  do what. http://www.roberthancock.com/dell/fpconn.htm was helpful for that.
However, the solutions of splicing wires or cutting up the housing seem like an unnecessary headache.
What are these plugs/cables called? :
If I can get a few male <-> female cable of these I can keep the original front panel cable intact and just utilize which pins I need for the new board. I'm not sure what these little 2 pin cables are called though?
Thanks in advance!