First post, by belzrebuth
I purchased a SB Pro2 a while ago and today that I got to test it I found out that the card has been damaged.
A trace near the IDE connector next to the resistor packs has been burned out (too much current maybe) and a jumper wire has been put in the back of the IDE connector as a failed repair attempt.
I removed the jumper wire and soldered a thin piece of copper wire on top of the burned trace but the card is still dead.(not recognised from Win95 ;as it's not even there)
I don't see any other signs of obvious damage but that only leaves me fearing the worst (ie burned ICs).
Here are some pictures of the card..
Is there any way to revive the card?
Maybe a jumper configuration?
I'm trying to use it on a socket5 motherboard with a 75mhz pentium.
Apparently I shouldnt have bought it in the first place but still..