stamasd wrote:Added DIN connectors for MIDI in, out and a DB15. If the DIN connectors don't fit you may have to mod the case, or leave them unpopulated.
You'll probably have to remove the original 9-pin connector if adding the others. All 4 connectors aren't going to fit in the case vertically (horizontally?) either. And yes, a case mod would be required to use the DIN connectors. Mini-DIN like some other boards have used might be a better idea. If someone has the skill to solder the components to the board, they can make a cable adapter without much trouble. One nice thing about the 9-pin connector, however, is the possibility of using a readily available bracket for the card instead of having to drill out a custom one. I'll check over the schematic later today.
I'm excited for the possibility of a board being available, even just a bare board being available where the end user has to solder down all the components would be an order of magnitude easier than wiring it up on a protoboard. You could always make it available on OSH Park or we could get a group buy together to get the cost down. Maybe this would also get some people involved who are better at programming than I am... While the software works, it is admittedly a hack to get SoftMPU working on the Atmega platform. I think there is a lot of potential for HardMPU with the right software running on it.