Hi all.
After much problem and a lot of mobo's, i finally managed to ret sb16 emulation to work om my sblive.
Now i want to get sound working in dyna blaster.

Was dynablaster sb pro or did it use a specific irq or some special switches when typing Dyna?
I only remember that sound was an issue back then when i wanted sound, and it was indeed working with sb16value wich was a good allround board.

EDIT:
Right... Solved this issue, regarding sound glitches in Dynablaster by a shere mistake in my configuration.
First up. I have disabled any LPT and COM ports, freeing up IRQ 5 and 7.
Next I have installed the SB16 as IRQ7, DMA1 and DMA5, finally the MIDI/MPU set at 300 plus tested with 330.

Now... (running with the SB16 installed)
If I try to use ANY cards at IRQ5, the game will not play sound effects, only music (wich is adlib).
If I try to use ANY cards at DMA3, the result is the same... No sound effects.
If I try to pull this off on any CPU higher than somewere between 200 and 500 mhz, no sound is playing.

Hope this will help anyone, who have had the same problem as I have had.
Note, that this has not been tested with any AWE cards or any PCI based cards, only a standard SB16.