Hi I just installed dosbox in my Linux Ubuntu dapper.

It works properly, but there's a problem with an old ISA (non-commercial) card.

I have too a DOS program who processes data read from this ISA card.
When I start dosbox I can run my DOS application, but It does not see any ISA Board.

I assume that I have to configure this device in config file used by dosbox, but I don not where to start.

The ISA card is eeprom reader/writer Built in the 90's for a school student, the DOS software too.

When I run the program in a DOS 5.0 machine I go directly to the software directory and run the exe file. Theres no special configuration un autoexec.bat and config.sys files.

Please Any help?