First post, by Solo761
Hello all,
does anyone has experience with this motherboard and support for CPU voltages beside 5V?
Ultimateretro has images of v2.0 which has few differences when compared with my v1.1. Mine looks like this (although it's not my image). Silkscreen on motherboard has listed all jumper combinations and this includes voltage settings (for 5V, 3.45V and 3.3V). Same with manual on ultimateretro which is for v1.1. But, as in the image in red square, my board doesn't have anything soldered to that point, which looks like that's where voltage regulator should be soldered to.
Were there v1.1 with this component installed and others without, here's another image I found, it has something that looks like voltage regulator plus heatsink installed in that spot. Although I can't say if it's also V1.1, or perhaps v1.0. V2.0 doesn't have this spot/component ?
Or it creates these other voltages some other way?