Reply 40 of 43, by Tom Lewandowski
config=x activates any MIDI device in my list, properly.
So, when I set config=3, the Yamaha MIDI port is properly accessed when I load the VAPIMPU driver.
config2=x doesn't work at all, even when set to "0" (the Audigy I/O), since I'm unable to load the SAPIMPU driver at I/O 332 to access it. SAPIMPU will only load with it's default setting of IRQ 2/9 330H. Unfortunately, SAPIMPU can't load unless VAPIMPU is FIRST loaded. And, SAPIMPU doesn't allow for specifying IRQ.
If I load SAPIMPU with its defaults (IRQ 2/9, I/O 330), it just uses the same device that's setup under "config=x", so that both SpG MIDI Port 1 and 2 access the same MIDI device.