First post, by Rodoko
- Rank
- Newbie
Two weeks before I decided to grab a case that had a 486 motherboard inside, the infamous PC-Chips M919 rev. 3.2
When I got the board from a friend in 2017, it did not work so I putted on a case and forget about it until this year where I installed a 486/66 and most of the components that came from my Pentium 200 and bam! it turned on, so after playing with the 486/66 a bit I decided to upgrade it to an AMD 5x86-133 ADW and the problems began
No matter on how I set the jumpers the board does not throw any video signal, just fans and hard drive spinning and that's it and also the jumper settings are driving me crazy a lot because some of them are not really accurate T-T
Games like Duke Nukem 3D tends to be choppy in 640x480 and I need to go back to 320x240 in order to play it correctly
So, anybody can help me?? I have a pair of those AMD processors and no one is getting warm unlike the 486 because the last one burns my finger in a manner of seconds
And speaking of the computer I did switch the front panel since I had an identical case, same front but different cover clipping system and also the PSU since the original one has a loose IEC connector
Specs in BIOS screen and the video card is a S3 Virge 375/385 with 2 megs of RAM and an ESS1869 sound card