VOGONS

Replace Dallas RTC battery without desoldering?

Topic actions

First post, by precaud

Posted on 
User metadata
Rank Member
Rank
Member

The answer is a qualified yes. As long as you have clear access to the side of the chip that has the terminals that need to be exposed, it is actually quite easy to do with the chip in place. You only need to be able to see what you're doing, and get the Dremel tip into the body of the chip without touching anything else. The material in these Dallas chips is quite soft, so the Dremel is easy to control..

Not having to desolder the chip turns this into an easy process. I did the DS12887 in an Intel Plato board this afternoon in a little over an hour. If it weren't for the 1/2 hour cure time needed by the epoxy, it would have taken about 40 minutes.

Reply 1 of 2, by JudgeMonroe

Posted on 
User metadata
Rank Member
Rank
Member

I’m glad this worked out for you! I just know if I tried it the Dremel would slip and tear up the board. Maybe I can mod the one I desoldered though. I have plenty of cr2032 saddles.

Reply 2 of 2, by precaud

Posted on 
User metadata
Rank Member
Rank
Member
JudgeMonroe wrote:

I’m glad this worked out for you! I just know if I tried it the Dremel would slip and tear up the board. Maybe I can mod the one I desoldered though. I have plenty of cr2032 saddles.

Thanks. I've done lots of board-levels repairs, and this one is neither difficult nor high-risk. The mass of the board actually stabilizes the cutting. What makes Dremmeling (a new verb?) dangerous is when the workpiece is not secured, or when the material is inconsistent, and the bit grabs and gets tossed around when it encounters different densities/materials. This is like cutting through butter. I kept the rpm's very low.

Go to top of page Go to top of page
Back to General Old Hardware
Close window
Close window