Hi,
I hope this is the right section (if not I'm sorry).

I have some problems displaying ANSI characters in MS-DOS 5.0 running inside DOSBox.
For example, if I run DOSMid in DOSBox I see this:

In MS-DOS installed inside DOSBox, I see this:

The same applies with ANSI characters in batch menus.
I tried adding DEVICE=C:\DOS\ANSI.SYS /X in CONFIG.SYS but it didn't solve the problem.
Is there something I can do to display those characters?
Maybe it's very simple to correct but I really don't know how to do it.

Any help would be greatly appreciated.
Thank you