First post, by scroeffie
iam almost done with my 486 big tower build ,only thing that wont work are the sound drivers or card dont know ,been trying sins this morning
i got the drivers from here http://dosdays.co.uk/topics/sb.php when i go to sbrpo than install its starts install the drivers but it says inflating not installing not shure what this means
i have the files on a usb stick installing them via gotek just like i did with dos
CT1600
FM synthesizer: YMF262 (OPL3).
DAC: YAC512.
Panasonic and Mitsumi CD-ROM connectors.
This is the "Sound Blaster Pro II", introduced in 1991.
A new single OPL3 chip replaces the old dual-OPL2 arrangement. Lower interference than CT1330 due to the new analogue low pass filter. Output quality is quite good, with low noise level, no audible distortion and packs a lot of power in the bass section. Perhaps a bit too bass'y compared to higher quality sound cards. In the mixer settings, the low pass filter is on by default. This can be deactivated with the SBP-SET utilities included in the drivers. This filter is supposed to be applied to digital audio, not FM.
The CT1336 chip is the bus interface chip.
Drivers
SoundBlaster Pro II Windows 3.1 and DOS Driver Updates for CT-1600 / CT-1680 / CT-1690 only
For the above set of drivers, If you have not already installed SB Pro drivers into Windows 3.1 and DOS, you must first download and install the drivers from the files SBP2WU.EXE and SBP2DU.EXE
i dont have any other hardware inside the pc just soundcard vga card and cf card adapter nothing else so i dont have any conflict i think