I had a nice system turn up today. I don't normally buy full systems, but this looked in great conditions and the parts looked to be really good also.

Its a Dan Mini Tower Intel 486 DX2 66mhz built in '94

Intel 486 DX2 66mhz
20mb ram (8x30pin Simm Modules)
Asus isa-486sv2 Rev 3.10 VLB motherboard (battery removed, no apparent damage)
Sound Blaster 16 CT-2830 SB16IDE (Genuine OPL3 onboard)
Promise VLB IDE Controller with 4mb cache
345MB Hard Disk
Cirrus Logic AcuMos ISA VGA Board
Serial/Parallel Card
Logitech Mouse Controller
Panasonic CD-Rom

Case is in lovely condition for its age. I've always liked these upside down towers. Bezel on the CD-ROM is yellowed so will try and sort that out.

I will upgrade the VGA Card to a Cirrus Logic VLB one i have and maybe fit a larger hard disk (1 or 2.1 gig)

Deksor wrote on 2020-05-06, 11:34:

The DX2 overdrive on the other hand is exactly the same as a normal LIF168 DX2.

Depends if the DX2 overdrive is ODP or ODPR.

It isn't exactly the same. It doesn't have test scan signals, different cpu id. I also believe that UP# pin is always driven low on overdrive chips even on ODPR.

Also overdrive chips are always write-through. Ordinary DX2 chips have write-back cache in certain sspecs.

PSU on the bottom... that was really ahead of its time 😀

Bancho wrote on 2020-05-06, 12:53:

I had a nice system turn up today. I don't normally buy full systems, but this looked in great conditions and the parts looked t […]
Show full quote

I had a nice system turn up today. I don't normally buy full systems, but this looked in great conditions and the parts looked to be really good also.

Its a Dan Mini Tower Intel 486 DX2 66mhz built in '94

Intel 486 DX2 66mhz
20mb ram (8x30pin Simm Modules)
Asus isa-486sv2 Rev 3.10 VLB motherboard (battery removed, no apparent damage)
Sound Blaster 16 CT-2830 SB16IDE (Genuine OPL3 onboard)
Promise VLB IDE Controller with 4mb cache
345MB Hard Disk
Cirrus Logic AcuMos ISA VGA Board
Serial/Parallel Card
Logitech Mouse Controller
Panasonic CD-Rom

Case is in lovely condition for its age. I've always liked these upside down towers. Bezel on the CD-ROM is yellowed so will try and sort that out.

I will upgrade the VGA Card to a Cirrus Logic VLB one i have and maybe fit a larger hard disk (1 or 2.1 gig)

Very nice. Now you just need to put Microsoft Bob on Dan.

Bancho wrote on 2020-05-06, 12:53:

I had a nice system turn up today. I don't normally buy full systems, but this looked in great conditions and the parts looked to be really good also.

nice 😁
I'm still always looking out for those inverted AT cases, but they always get crazy expensive.
...

got a few sound cards :3

Terratec Maestro 16/95 Ver. 1.0 (16/96)
in box with tiny speakers and all goodies, partly still sealed, I think this one is actually new.

Terratec Base-1, I already had one of these, but got it for the wavetable board, Terratec WT64

míro Sound PCM1 Pro... after missing out on the one in a scrap lot I now got one with manuals :3

Guillemot Maxi Studio ISIS, seems complete

imi wrote on 2020-05-06, 13:48:

nice :D I'm still always looking out for those inverted AT cases, but they always get crazy expensive. ... […]
Show full quote

Bancho wrote on 2020-05-06, 12:53:

I had a nice system turn up today. I don't normally buy full systems, but this looked in great conditions and the parts looked to be really good also.

nice 😁
I'm still always looking out for those inverted AT cases, but they always get crazy expensive.
...

just flip a case upside down?

that is not the same :p
the inverted cases have a very distinctive style, less tall, with the drive bays shifted to the side.

Back in the day, one of local pc stores that I worked at and many stores around used those fat and short towers with those plastic rails, these were specially made so drives is not loose when installed.

Cheers,

My Slot-1 rig is slowly getting there.

Bancho wrote on 2020-05-06, 12:53:

https://i.imgur.com/dlDAEYTl.jpg https://i.imgur.com/4vtZo45l.jpg […]
Show full quote

This is my favourite Baby AT case style, I hope one day I will find one nearby without having to pay 100€ for shipping.

My P133 is in an inverted case. It is cool indeed 😀

Bancho wrote on 2020-05-06, 12:53:

I had a nice system turn up today. I don't normally buy full systems, but this looked in great conditions and the parts looked to be really good also.

<snip>

Looks like it came from the same factory as this case, only a bit later 😀

^ that's the exact case I want ^^

Cyrix200+ wrote on 2020-05-06, 14:57:

Looks like it came from the same factory as this case, only a bit later :) […]
Show full quote

Bancho wrote on 2020-05-06, 12:53:

I had a nice system turn up today. I don't normally buy full systems, but this looked in great conditions and the parts looked to be really good also.

<snip>

Looks like it came from the same factory as this case, only a bit later 😀

I had one of those back in 1990’s
I never used it however because I did not have the hard drive rails.
I regret sending it to the recyclers.

Nice case.

I got a auzentech prelude and forte a couple of weeks and just got around to using them. The forte needs a heat sink because the rev.1 cards like to kill themselves.

imi wrote on 2020-05-06, 15:00:

^ that's the exact case I want ^^

My dad's 386SX 16MHz came in this case. That's the machine I gamed on for a loooong time 😀

I was very happy when I finally found this case again. I have two now...

Cyrix200+ wrote on 2020-05-06, 15:23:

have two now...

oh nice, so that means I can have one? :3c

ShovelKnight wrote on 2020-05-05, 14:16:

It's not really retro but I bought a small mixer to plug all my PCs (modern and vintage) into it. Works a treat and helps to mitigate noise issues with old sound cards.

I was looking for a while too, stereo mixers are a rare breed, I've already got a behringer RX1602 but I finally found the one I was looking for at a local music store after multiple failed attempts on ebay, and its retro!
also some other stuff ...now I can get some more midi modules :3

imi wrote on 2020-05-06, 13:48:

míro Sound PCM1 Pro... after missing out on the one in a scrap lot I now got one with manuals :3
hardware38_45.jpg

Very cool. Do you know if this card can access the OPL4 for GM music from DOS?

unfortunately not afaik.