Epson Linx 8086 motherboard - questions \ VOGONS

Epson Linx 8086 motherboard - questions

Topic actions

First post, by pshipkov

Posted on 2024-03-11, 04:44

pshipkov Offline

Rank l33t

Rank: l33t
Posts: 2022
Joined: 2018-10-11, 05:08

Recently got this guy from EBay.
The power connector appeared AT standard in the listing's photos, but that is not the case. Any idea what the pinout is ?

20240310_212802.jpg

Couldn't find any references about this board online. Anyone ?

20240310_212754.jpg

Thanks in advance.

retro bits and bytes

Reply 1 of 1, by snufkin

Posted on 2024-03-11, 15:17

snufkin Offline

Rank Oldbie

Rank: Oldbie
Posts: 1196
Joined: 2021-03-18, 18:58

If no one has any information, any chance you could use a multimeter to check which pins on the ISA slots go to the power connector? e.g. hold one probe on B3, check for continuity to each of the 12 pins and any that measure short are +5. I think B1 is Ground, B5 is -5V, B7 is -12V and B9 is +12V. Any power pins that you don't identify would need a bit more figuring out.

Go to top of page Go to top of page

Back to General Old Hardware