gsos wrote on 2026-09-23, 01:58:@Solutor and @LSS I’ve updated the release with a USB image that supports both BIOS and native UEFI: […]
Show full quote
@Solutor and @LSS I’ve updated the release with a USB image that supports both BIOS and native UEFI:
https://github.com/gerben-stavenga/RetroOS/re … ses/tag/retroos
Download retroos_grub_module.iso and write it directly to a USB stick using an
image writer (choose DD/raw mode if prompted). The older image.bin.zip is BIOS-only.
On your HP, select the UEFI USB entry in the firmware boot menu, without CSM/
CSMWrap. Start with the default Protected disk option. UEFI uses the GOP
framebuffer; BIOS boot also offers native VGA or a VBE framebuffer.
If your HD is fat then it becomes C: (if protected is chosen it has a ram-overlay)
If your HD is ext4 then /home/retroos becomes C:
I just tested on my system but no difference. Still hangs. Some further contexts:
I've a fully working dISAppointment v0.2 setup on that system, with a Sound Blaster 16 PnP (CT2950) behind it. The card is not accessible by default. I need to set up proper I/O forwarding to the LPC bus to make the card accessible and configurable via UNISOUND. As such, the boot process usually involves booting to DOS (Win98SE's MS-DOS 7.10 is sufficient) with no device drivers, run the programs that I use to set up the necessary registers, run UNISOUND to initialize the card, and finally launch GRUB4DOS to boot the RetroOS kernel. As such, the boot environment may be a bit dirty but most OSes (including WinNT family) that I'd like to use the ISA sound card with are tolerant enough not to encounter any issue. Additionally, if initialized via UNISOUND beforehand, a PnP Sound Blaster compatible card can then use non-PnP Sound Blaster drivers.
I don't know if RetroOS kernel can do the following customizations through a config file during initialization:
- Configure certain PCI configuration register values.
- Write to I/O ports. (DMA registers need to be cleared for LPC/ISA DMA to work correctly on most supported boards.)
- Initialize PnP Sound Blaster compatible cards similar to UNISOUND.
On my board I've disabled its onboard HDA because it explicitly wanted IRQ7 which I'm using it for the Sound Blaster 16 card.
I cannot use IRQ5 on that system because almost all onboard devices wanted it. Disabling the HDA allowed IRQ7 to be free as other onboard devices don't seem to prefer it.
So on that system the only way to enable sound for now is through the Sound Blaster card which I need to initialize before I could use.
I'm not sure if in the future additional sound card support can be added. I'm currently using a PCIe Sound Blaster clone that appears to the system as an Audigy (SB0090) on that system.
EMU10Kx family is well supported across many OSes (Windows, Linux, Haiku/BSD, etc.). The Sound Blaster clone actually works on Win98SE using Audigy VxD drivers.
Anyway, I'm going to try this on my other systems as this one isn't going anywhere for now...
BTW: Can RetroOS load DOS TSRs? Actually, on one system I need to use EGAFIX and NEWAX to patch crippled VGA and VESA functionalities of my nVidia video card. Otherwise games may not work correctly. If not, perhaps I need to assess the performance of the software VBE/GOP framebuffer...