Normally, it only asks for oemsetup.inf if you select a mouse driver that does not come with Windows. What type of mouse did you select in the setup?

Did you run Setup from within the Windows directory ?

Use the generic PS/2 or Serial (Depends on your mouse's connection) driver and it should work just fine :3

DerSammler I chose express setup when installing 3.11 so it didnt detect a mouse and it didnt install any type of mouse, Jo22 I installed 3.11 from floppy and I used setup.exe or setup.com from the first floppy there are 9 disks I will look in the Windows dir to see it there is a setup.* to see if it will install a mouse as it sits right now but I have tried going to "Windows Setup" then "change system settings" then change "no mouse" to "install a mouse" and this is where it asks for the location of the mouse files so I tried my C:\Mouse folder it has 3 different mouse executable files ie: ctmouse.exe, mouse.com, bbbmouse.com but Windows does not like them and asks for the location of OEMSetup.inf, Rodoko I have loaded Dos using a mouse like ctmouse but when I run windows it does not transfer over and the mouse is not there.

I think I will just reinstall 3.11 and keep this in mind that a mouse should be connected at the time of install.

You need to run setup.exe from the Windows folder from DOS. Then select a mouse from the list.

Trying to do that from the Windows-based setup will ask for a third-party driver disk. Also, mouse drivers for DOS will not work. You can't use ctmouse.exe and the like for Windows.

Thanks DerSammler that worked well it asked for floppy disk number 2 and it was fast.