Hi all,
Thanks a lot for this software!
I've just a little question: i have an old software (reachout) that is a vnc like and run into windows 3.1 but i can't have my physical modem recognised.
Could you help me please?
Thanks in advance.
did you change the serial1= in dosbox.conf?
1+1=10
Ok now i can see the modem but there is some other problems.
I think that my modem don't understand all the commands send by the software (unhandled command) and finally when i want to connect to the other host by is phone number, i have a : modem response: NO CARRIER.
The listening port is the port 23.
Is there another port to set?
Or another thing to do?
Thanks in advance for your help!
Do you want to communicate by a real modem built into your computer? In that case you need to use directserial, not modem.
1+1=10
ok i have set directserial but i don't know what to put in realport?
Thanks a lot for your help!
the comport of your modem
Water flows down the stream
How to ask questions the smart way!
ok perfect!
Now i can make the phone number but there is another problem.
(desired serial mode not suppported) and the software freez on:
"login on to host"......
I'm sorry but no one has an idea?
Nope.
But feel free to post a screenshot of the error.
> desired serial mode not suppported
can probably be ignored.
Does the DOSBox Status Window show some error messages?
Try a CVS build too.
1+1=10
that's the log:
I'm now trying to install a CVS one.
As it tries to use the FIFO you could try the build from my homepage too. 5 and 6 are weird baud rates though...
1+1=10
everything is ok now.
i need to do a "ctrl+esc" in the dosbox but when i do that dosbox crashes...
is there a special key to press to do that?
thanks for your help!
check the readme (mapper section)
