First post, by keropi
- Rank
- l33t++
Hiya!
I have an old ST351A/X HDD and I think it's a perfect match to finally test this JUKO 8BIT IDE controller:
So I found on Seagate's FTP the drive's jumper settings: http://computermuseum.informatik.uni-stuttgar … /ASCII/4252.TXT
I can't really understand it, must be getting senile 🤣 😵
What jumpers to I close to make it work? 7-8 is the obvious one to enable "XT MODE" , do I also need 1-2 and 11-12 ?
I am also unsure of the jumper settings on that controller as well 🤣
Any help as always is greatly appreciated 😊