ST351A/X XT mode jumper settings \ VOGONS

ST351A/X XT mode jumper settings

Topic actions

First post, by keropi

Posted on 2017-08-30, 11:36

keropi Offline

Rank l33t++

Rank: l33t++
Posts: 9801
Joined: 2003-09-08, 06:45
Location: Greece

Hiya!

I have an old ST351A/X HDD and I think it's a perfect match to finally test this JUKO 8BIT IDE controller:

So I found on Seagate's FTP the drive's jumper settings: http://computermuseum.informatik.uni-stuttgar … /ASCII/4252.TXT
I can't really understand it, must be getting senile 🤣 😵
What jumpers to I close to make it work? 7-8 is the obvious one to enable "XT MODE" , do I also need 1-2 and 11-12 ?

I am also unsure of the jumper settings on that controller as well 🤣

Any help as always is greatly appreciated 😊

🎵 🎧 ⏳ ⚡ SoundVision PRO,MK1869 , PCMIDI MPU , OrpheusII , Megacard and 🎶GoldLib soundcard website
💾💾💾 Looking for a full version of LIST ENHANCED 2.4y1 by V. Buerg, message me if you have it for sale! 💾💾💾

Reply 1 of 2, by Errius

Posted on 2017-08-30, 19:14

Errius Offline

Rank l33t

Rank: l33t
Posts: 2989
Joined: 2015-12-16, 19:16
Location: Lave Station

I have several of these but haven't dared mess with the jumpers yet. Please let me know which settings cause yours to blow up.

Is this too much voodoo?

Reply 2 of 2, by Matth79

Posted on 2017-08-31, 17:28

Matth79 Offline

Rank Oldbie

Rank: Oldbie
Posts: 852
Joined: 2014-05-19, 14:24

I'd guess you leave the "bus reset" jumper in whatever position it was in, appears it MUST be on one of those positions, but "system dependent" does not convey much, and the setting quietly disappeared from other drives, did that mean it standardized low, or high?

Go to top of page Go to top of page

Back to General Old Hardware