Reply 1 of 8, by keropi
- Rank
- l33t++
99% these will work just fine - I have the same card but with the 90C30 chip:
Reply 2 of 8, by jasa1063
- Rank
- Oldbie
keropi wrote on 2021-05-17, 19:33:99% these will work just fine - I have the same card but with the 90C30 chip: […]
99% these will work just fine - I have the same card but with the 90C30 chip:
Thanks, I will give that a try.
Reply 3 of 8, by jasa1063
- Rank
- Oldbie
Those settings worked for my monitor. I just need to figure out the jumpers. One has to be for memory zero wait state.
Reply 4 of 8, by pentiumspeed
Hi there, which jumper is for zero wait state?
Cheers,
Great Northern aka Canada.
Reply 5 of 8, by maxtherabbit
- Rank
- l33t
The 0WS jumper is 95% of the time physically connected to the 0WS ISA pin (B8). Just buzz it out with a meter
Reply 6 of 8, by pentiumspeed
Cool, good to know, that something I can do! I repair electronics for a living so I know what to do with meter.
Cheers,
Great Northern aka Canada.
Reply 7 of 8, by keropi
- Rank
- l33t++
that jumper left of the ROM chips should be the 0WS one - I give it 95% chance 🤣
Reply 8 of 8, by jasa1063
- Rank
- Oldbie
keropi wrote on 2021-05-18, 20:06:that jumper left of the ROM chips should be the 0WS one - I give it 95% chance 🤣
Correctamundo:)