I am looking for the jumper settings for this card. I found some that are close, but not this particular card on stason.org and TH99.
99% these will work just fine - I have the same card but with the 90C30 chip:
keropi wrote on 2021-05-17, 19:33:99% these will work just fine - I have the same card but with the 90C30 chip: […]
99% these will work just fine - I have the same card but with the 90C30 chip:
Thanks, I will give that a try.
Those settings worked for my monitor. I just need to figure out the jumpers. One has to be for memory zero wait state.
Hi there, which jumper is for zero wait state?
Cheers,
Great Northern aka Canada.
The 0WS jumper is 95% of the time physically connected to the 0WS ISA pin (B8). Just buzz it out with a meter
Cool, good to know, that something I can do! I repair electronics for a living so I know what to do with meter.
Cheers,
Great Northern aka Canada.
that jumper left of the ROM chips should be the 0WS one - I give it 95% chance 🤣
keropi wrote on 2021-05-18, 20:06:that jumper left of the ROM chips should be the 0WS one - I give it 95% chance 🤣
Correctamundo:)
