Have you tried contacting Lian Li directly? They might still have them, even though they're not listed on their website.

If you still have intact ones for measurement and/or scanning, you could probably get some 3D printed.

paradigital wrote on 2021-12-30, 16:42:

If you still have intact ones for measurement and/or scanning, you could probably get some 3D printed.

Would definitely want a resin printer to do something like this. A PDM printer would not make the parts strong enough.

I have a case that uses these clips as well. I think I have epoxied all of my clips though so not sure if I could take accurate measurements.

These look like reproductions, but they ought to work: https://www.ebay.com/itm/184719688030?chn=ps& … qhoCyboQAvD_BwE

Thanks very much for replies, unfortunately those are US ebay and it would cost more than I paid for the whole case just to get them shipped to UK, I'll keep looking, sure I'll come up with some bush fix or other. 🙄
Apart from the USB cover flap missing it's in very good condition.
Hate it when flaps are missing............. 😋
Might give Lian Li themselves a try like debs3759 suggested.

Lee

They're avaliable on thingiverse. I've had my brother print some for me and they turned out pretty well. 3D print is certainly strong enough.
https://www.thingiverse.com/thing:215612