Been filling out the pads, nets and playing with the layout some. can I get your guys feedback on clearance issues?
Many things left to adjust, but the device is starting to take shape.
the holes are still set to .016" for a while I was thinking shim style with pres fit for this, after further research I'm seeing a interposer is just gonna have to be the way to go. unless I wanna make three variants for 6 oclock, 9 oclock and 12 oclock for clearance reasons on different motherboards. a motherboard style tweaker may also come of this.
The clearance under the cpu inside the socket has always been kinda scarce but when you take into account blue sockets, it basically makes a shim style impossible. without locating everything oposite the lever or oposite the crank and there are usually clearance issues there.
I'm looking for people to verify these mods before I take this out of alpha.
Need to test the three different multiplier pins. (http://ps-2.kev009.com/eprmhtml/eprmx/h12203.htm)
Need to test the blend pin function (see video from earlier)
Need to test the cache pin function (see video from earlier)
Need to test wt/wb (which is a pin shared with one of the multiplier pins but for different cpu)
need to investigate definitions for j1, s4 and see if they can be tied to the voltage planes