First post, by otipher
I'm new to working with Glidos, although I did get it working with Tombraider without too much trouble. I have also installed VDM with the updates.
However, I'm still not having much luck at all with the retail version of Blood. When I launch Blood from Glidos, I can get up to the 3DFX alpha messages, hit space to continue, a few logging messages appear, but cannot be read before the DOS box vanishes.
I found a few threads on the Blood topic on these boards, and the two areas that I am left unclear about are:
1. which (or both) of Glidos v1.2 or the special Blood Glidos have to be used for a chance of success
2. the detailed instructions at the Glidos page for Blood make no mention of running the Setup program that comes with Blood, which would seem to be a prerequisite before running Blood under Glidos?
If someone could elaborate on these two points above, then I will be in a good position to provide more troubleshooting info to any fellow Blood/Glidos users out there feeling generous enough to help me out.
thanks!
Chris