RetroLizard wrote on Yesterday, 19:37:What about something like this?
99% far opposite of quiet.
If you have the mounting holes: thermaltake SonicTower. With a rear case fan easily passive.
tehsiggi wrote on Yesterday, 19:46:RetroLizard wrote on Yesterday, 19:37:What about something like this?
99% far opposite of quiet.
If you have the mounting holes: thermaltake SonicTower. With a rear case fan easily passive.
I don't think that would fit in an MSI K7N2/MS-6570 motherboard, unfortunately.
Maybe get creative?
The physical size of a socket A heatsink is 60mm X 60mm.
You can get a waterblock that size from Amazon.
https://www.amazon.com/Marhynchus-Cooling-Alu … m/dp/B089295857
Sadly it's all aluminium, not all copper, but at 12mm thick, this is similar to the 'solid part' of a socket A cooler, so the 'retention strap' could be bamboozled into going over the top to hold it down.
You could then mount a liquid radiator at the back of the case with some quieter 60mm fans on it.
I have been restoring my computer desk for couple weeks now... after finally converging the Nokia on it and putting all together, after some 2.5 years later 🤣
..Compared to earlier state, there are 3 new things :
* Extron VGA matrix with 8 inputs and 4 outputs (input from KVM, HDMI matrix and several high value sources into both monitors and projector above it all)
* Noname HDMI matrix with 6 inputs and 2 outputs (all DVI and HDMI devices, with one output to LCD and other via VGA dongle to the VGA matrix)
* 10 stereo input mixer that I built not so long ago, with ground loop cancelling inputs so no buzzing noises and anything of the like ~
The cables are a mess but I will make a much more tidy and permanent setup when I have moved to a house, which will hopefully happen in not such a long time
I also need lesser computer speakers, the right one is in such a suboptimal location...
---
Yesterday evening I made an ATX power extender since the cables didn't reach from PSU to the power header on my test setup that is being restored too. The mobo got extended a bit and the cables just didn't reach on the PSU...
---
Today I finally got the test computer going and I can do some misc hardware and software tests again. I need to get one of those test jig things so at least the cards are secured... My nice KVM cable barely reaches too...
T-04YBSC, a new YMF71x based sound card & Official VOGONS thread about it
Newly made 4MB 60ns 30pin SIMMs ~
mida sa loed ? nagunii aru ei saa 😜
tehsiggi wrote on Yesterday, 19:46:RetroLizard wrote on Yesterday, 19:37:What about something like this?
99% far opposite of quiet.
If you have the mounting holes: thermaltake SonicTower. With a rear case fan easily passive.
+1
Had this back in 2003-4 with my Athlon XP system passive
Tiido wrote on Yesterday, 21:10:I have been restoring my computer desk for couple weeks now... after finally converging the Nokia on it and putting all together […]
I have been restoring my computer desk for couple weeks now... after finally converging the Nokia on it and putting all together, after some 2.5 years later 🤣
..Compared to earlier state, there are 3 new things :
* Extron VGA matrix with 8 inputs and 4 outputs (input from KVM, HDMI matrix and several high value sources into both monitors and projector above it all)
* Noname HDMI matrix with 6 inputs and 2 outputs (all DVI and HDMI devices, with one output to LCD and other via VGA dongle to the VGA matrix)
* 10 stereo input mixer that I built not so long ago, with ground loop cancelling inputs so no buzzing noises and anything of the like ~The cables are a mess but I will make a much more tidy and permanent setup when I have moved to a house, which will hopefully happen in not such a long time
I also need lesser computer speakers, the right one is in such a suboptimal location...
---
Yesterday evening I made an ATX power extender since the cables didn't reach from PSU to the power header on my test setup that is being restored too. The mobo got extended a bit and the cables just didn't reach on the PSU...
---
Today I finally got the test computer going and I can do some misc hardware and software tests again. I need to get one of those test jig things so at least the cards are secured... My nice KVM cable barely reaches too...
One of the hardest things: arrange your computer desk to fit everything with limited real estate.... Nicely done!
🎵 🎧 ⏳ ⚡ SoundVision PRO,MK1869 , PCMIDI MPU , OrpheusII , Megacard and 🎶GoldLib soundcard website
💾💾💾 Looking for a full version of LIST ENHANCED 2.4y1 by V. Buerg, message me if you have it for sale! 💾💾💾
