Another success today was joining the "Tualatin + BX" club - ABIT BX133-RAID and a Tualeron 1.3GHz.

Did the pinmods as per this modding guide, got it to work properly and didn't need more to do to the CPU:

- removed AN3,AJ3, AK4
- made a wire wrap around AK26 and then soldered the other end to where AK4 pin once was
- ???
- p r o f i t

The bridge between AK36 and AM34 wasn't needed - I measured for continuity between AK36 and any given GND point on the mobo and found out it's grounded. YMMV though, depending on the mobo used.