Vertical collapse on IBM 5153 \ VOGONS

Vertical collapse on IBM 5153

Topic actions

First post, by geiger9

Posted on 2026-07-01, 18:57

geiger9 Offline

Rank Newbie

Rank: Newbie
Posts: 82
Joined: 2020-07-22, 02:48
Location: Canada

Hey all. Looking for help troubleshooting vertical collapse with a CRT monitor. It's an IBM 5153 so a fair bit old. Here's what I've done so far:

- looked for cracked solder joints and broken traces
- removed the v.hold and v.size pots from PCB and tested them
- tried injecting a vertical signal directly into the sync processor
- replaced the sync processor IC (Q402)
- recapped the board
- removed the three transistors in the vertical circuit and tested them
- checked resistor R312 which, according to one forum user, caused his vertical collapse.

The most recent thing I did was check the voltages on the three transistors in the vertical circuit while the monitor was running:

Q301
b 0V
e 0V
c 48.5V

Q302
b 48.5V
e 49V
c 120V

Q303
b 48V
e 49V
c 0V

I don't know what these values can tell me or what my next steps should be. Hoping someone can help.

Reply 1 of 2, by MagefromAntares

Posted on 2026-07-01, 19:13

MagefromAntares Offline

Rank Member

Rank: Member
Posts: 297
Joined: 2026-04-28, 00:23
Location: Hungary

Hi,

While unfortunately I personally don't own a 5153 monitor, as I intend to add one to my collection in the future(If I find one that seems to be in at least in "fixable" condition and not insanely overpriced) I already checked for the availability of the service manual and it is on archive.org:
https://dn721801.ca.archive.org/0/items/sams- … 05153%20VDU.pdf
It might contain enough information to help debug this issue.

"A process cannot be understood by stopping it. Understanding must move with the flow of the process, must join it and flow with it." - Dune

Reply 2 of 2, by geiger9

Posted on 2026-07-01, 19:39

geiger9 Offline

Rank Newbie

Rank: Newbie
Posts: 82
Joined: 2020-07-22, 02:48
Location: Canada

MagefromAntares wrote on 2026-07-01, 19:13:
Hi, […]
Show full quote

Hi,

While unfortunately I personally don't own a 5153 monitor, as I intend to add one to my collection in the future(If I find one that seems to be in at least in "fixable" condition and not insanely overpriced) I already checked for the availability of the service manual and it is on archive.org:
https://dn721801.ca.archive.org/0/items/sams- … 05153%20VDU.pdf
It might contain enough information to help debug this issue.

Hey thanks for checking out my post. I've already been looking at the service manual and I've followed the steps in the troubleshooting section for no vertical deflection.

Go to top of page Go to top of page

Back to Video