Installed in vmware 20H1 and worked w/o problems at the first try

I didn't expect it had even Glide support. So if the good day is seen from the morning... 😉

LSS10999 wrote on Today, 07:33:

I just noticed you've updated the artifacts in the Release. […]
Show full quote

I just noticed you've updated the artifacts in the Release.

I'm a bit confused. The "machine" package seems to suggest I need to run this from... an existing Linux install with ext4?

Originally I considered putting kernel.elf on the same boot partition (FAT32) that I used for everything from DOS to Windows just I wasn't able to boot it using GRUB4DOS' "chainloader". Will consider trying booting it using "kernel" directive again but what do I need to put in the folder that would be "C:\RETROOS".

I'm currently assuming "C:\RETROOS" would be the exact folder on my DOS boot partition (FAT32), but some docs seem to suggest this folder be virtual and read-only so I'm not sure...

I kind of understood the details after reading the BOOTING.md.

I tried to actually boot the kernel via GRUB4DOS after extracting machine_boot.tar to my target machine's main boot partition (FAT32), using "kernel" directive with "ram-overlay". It launched but alas it failed to boot.

1!!! FATAL !!!
2at arch-metal/src/traps.rs:1054
3Unhandled exception in arch: int=0x6 err=0x6 at 0x0008:0xc0ba3a60
4
5RetroOS kernel master-pre-ff-20260807-224-g48643746*
6Stack trace:
7   0: 0xc0ba4427
8   1: 0xc0bbea97
9   2: 0xc0b9ee42
10   3: 0xc0bbe1aa

(Written down manually after taking the photo of the error message on the screen.)

Not sure if this error message contains any possible hint. I'm testing this on my X99 system and the SATA disks are AHCI.