Hiya, it's my first post on the website, so hello!

I use CRT's daily because i prefer the way the image looks, whether that's for retro applications or modern day use.

Although i know my way around CRU and stuff like that there is one hurdle that i keep running up against;

Interlacing on Windows 11, i know it's possible over the IGPU however i would like to request a good recommendation as
I've purchased wrong ones before that capped out at 175Mhz (Not enough for a lot of higher resolutions)

Ideally i'd have one that goes HDMI in to the Motherboard and accepts VGA from my CRT.
My intended resolution to run is 2880x2160i

I have attempted a dual GPU-passthrough setup before with a 3080 TI and a 980TI however the driver that allows both cards to be detected fails to accept interlacing from the 980 TI on W11.

If anyone has some tips, tricks, or recommendations i'd be happy to hear them.

- Cayde Vanlue