H3nrik V! wrote on Yesterday, 14:58:
... I had inteded to swap the middle and left button microswitches, since I use the serial mouse for retro rigs only, where the middle button is rarely used. Measuring revealed the problem was elsewhere, though.
Yeah, except for a couple of obvious times were their tails got pulled off/out or cut off, I don't think I've ever fixed a mouse where the problem wasn't worn out microswitches.
For years, my technique was to swap the left and middle (or right on two button mice) cuz left is bar far the most used... I later started swapping them out for much more robust ones .
I eventually decided I liked the "feel" of the firmer click more, so a few I've swapped out both right and left (I use middle least a not enough that it matters - also nice for it to have a different feel).
I've got quite a stash of firmer little square microswitches with the round black "button" in the center - during my career I've had quite a bit of industrial/keypad equipment come my way, and pretty much any I decide no to keep, I salvage the buttons from.
I've got a few much softer buttons, which are similar size and shape, "button" is longer and a bit flexible. These are also quite reliable and make good contact, but I really don't like the "feel" - you can't really feel when it "clicks" ... so I don't use then (at least for mice repair 😀 )
https://dunfield.themindfactory.com ; "Daves Old Computers" ; SW dev addict best known:
ImageDisk: rd/wr ANY floppy PChw can ; Micro-C: compiler for DOS+ManySmallCPU ; DDLINK: simple/small filetransfer(w/o netSW)via Lan/Lpt/Com