VOGONS


P2B doesn't like FDD

Topic actions

First post, by Kouwes

User metadata
Rank Member
Rank
Member

The other day I built a Win98SE PC with THW following specs:
Aus P2B with 384MB RAM, Pentium II-450, a 20GB Harddrive, Geforce 4 440MX, SBLive! CT4760 and Voodoo 2 SLI.
Everything was working fine until after a week or so the PC reported a FDD error while posting.
So I tried another known working FDD which gave me the same error.
I then removed the cables from the drive, don't need it anyway - and I have no 3.5" cover for this particular case.
The system works fine after I removed the 3.5" from the BIOS. I wonder if the onboard floppy controller died?

Reply 1 of 3, by H3nrik V!

User metadata
Rank l33t
Rank
l33t

Isn't the floppy controller an integrated part of the 440BX chipset, though?

Did you check and double check cable orientation and which connector you used etc.?

If it's dual it's kind of cool ... 😎

--- GA586DX --- P2B-DS --- BP6 ---

Please use the "quote" option if asking questions to what I write - it will really up the chances of me noticing 😀

Reply 2 of 3, by Ydee

User metadata
Rank Oldbie
Rank
Oldbie

I had a similar experience with the MSI K9VGM, where—after initially working without any problems—a “FLOPPY DISK FAIL (40 or 80?)” error message started popping up at startup.
Nothing had changed in the PC, and nothing had been installed. I thought the floppy drive had broken, so I replaced it with another one, and everything worked again. Just to be sure, I tried the one I’d removed in another PC, and to my surprise, it worked there. So I put it back in the original PC, and everything worked again. I was unable to figure out what the problem was or why it happened.

I'd try clearing the CMOS and booting with the “fail-safe” option to see what happens.

Reply 3 of 3, by Kouwes

User metadata
Rank Member
Rank
Member

I might give that a try...
Forgot to mention that I also tried another cable, from my bench PC where the drive is working just fine.
Another thing I observed is that after the floppy error appeared Win98 would freeze during startup, at the part where the splash logo briefly switches to DOS text. Changing the boot order in the BIOS, from cd, c to c CD fixed that.