Hi, thank you for the detailed response, and no, at 200hz it’s still very far from ideal. Any user sensitive to such nuances can verify this themselves by launching any FPS game with vertical sync enabled (or simply with a stable match between the game’s frame rate and the screen refresh rate) on any available version of Windows (98 and above), first setting it to 500Hz and assessing the smoothness of the mouse movement in the game, and then lowering this value to 200hz. The difference should be immediately noticeable (provided the user is generally attentive and meticulous about such things). The same thing is observed in DOS\Windows.
When the refresh rate in the game is a multiple of the mouse refresh rate, it’s even less noticeable. For example, at 100hz\200hz, the difference is less noticeable if you don’t make sudden and rapid movements that provoke deviations in the frequency from the base (200hz), which immediately disrupts synchronization and manifests as image jitter. However, when the refresh rate is not a multiple at all - for example, 70hz\125hz, 70hz\100hz, or even 70hz\200hz - this becomes very noticeable: the image literally always trembles a little, compared to 70hz\500hz on Windows, where the image moves truly smoothly (realistically) with the mouse.
A higher frequency, such as 500hz, fully compensates for any polling frequency drops, even during very fast and sharp movements. Frequency drops no longer affect the smoothness to the extent that it can be noticed. Therefore, the movements look realistic. At least, that’s roughly how I understand the observed difference in mouse behavior between DOS (200hz) and Windows (500hz).
Yes, the frequency under DOS can be adjusted using a mouse driver (TSR), but only for PS/2 connections (Not USB). For USB connections, I haven’t found any fully functional mouse driver yet that supports any change in the polling frequency for USB (Always 125hz, with any driver).
And yes, you’re right that 200hz is better than 100hz (the default for PS/2). Furthermore, 125hz (with a USB connection) is relatively suitable for games that run at 60hz(60fps), provided you don’t make sudden and fast movements. But still, it’s not the same and not as good as on Windows (500hz).
As for Quake I, it uses 72fps by default and vertical synchronization is enabled (if Write Combining works). Therefore, neither 100hz, nor 125hz, nor even 200hz in any way correlate with this value (200\72»2,777777). 500hz is almost perfect. But in DOS, unfortunately, so far 500hz cannot be configured in any way. Windows only).