thrustmaster cougar profiles in DosBox 0.74 \ VOGONS

thrustmaster cougar profiles in DosBox 0.74

Topic actions

First post, by cal603

Posted on 2012-02-26, 02:46

cal603 Offline

Rank Newbie

Rank: Newbie
Posts: 3
Joined: 2012-02-26, 02:30

I have a Thrustmaster cougar that I would like to compile programs for to be used in DosBox 0.74. Any profile that I program and compile in Win7 is ignored when I run DosBox, and I have to use the keymapper instead to program the buttons on the stick and throttle manually, but I don't want to have to program the thrustmaster using the keymapper. Any idea how to get a Thrustmaster cougar profile to work inside Dosbox? Thanks.

Reply 1 of 2, by Mr_Blastman

Posted on 2012-03-12, 18:50

Mr_Blastman Offline

Rank Member

Rank: Member
Posts: 130
Joined: 2005-07-26, 02:53

My Cougar works fine in dosbox. Are you assigning your key inputs via the macro file (.tmm) in conjunction with the .tmj file?

Reply 2 of 2, by cal603

Posted on 2012-03-31, 20:07

cal603 Offline

Rank Newbie

Rank: Newbie
Posts: 3
Joined: 2012-02-26, 02:30

I load a profile(a tmj and tmm file) and then I start up dosbox and the profile is ignored when I make any button presses. The axes all work fine, I just want the profile to work within it rather than having to map out the keys to the buttons in the keymapper. How did you get a profile to work in dosbox as you programmed it. Thanks.

Go to top of page Go to top of page

Back to DOSBox General