First post, by dank0
- Rank
- Newbie
Hi Guys,
I get CT2760 from Ebay. But I cannot get the card working.
I'm getting error message : 1010: Invalid "/BLASTER=D:x" argument.
I tried to change the DMA from 1 to 0 or 3 with same issue.
Diagnose will check the base, IRQ, MPU, but it will not pass the low DMA setting.
I also tried to boot linux HW diagnostic utilities and one of them sees the Awe on irq 10, dma 0 base 220.
I took all cards from the pc out and kept only the awe32. I Reset the bios to default settings, checked the settings to manual, nothing really changed.
So I just want to ask if someone here had same experience. I was excited that I got sound card with OPL3, Daughter Board Connector and Memory. It is hard to just take the card and trash it 🙁