Both would run at the same timings, so yes. If 70ns works then 60ns definitely will.

I have those two 16 megabyte modules (VIS-60ns).
Then I have one 16 megabyte 70ns.
One 8 megabyte 60ns from IBM.
And finally one 8 megabyte 70ns from Samsung (I think it is Samsung).

They should all come in hand one way or the other. 😜 Thanks 😀

They should work, as long as their paired in same size, since the controller does 16bit's to both rams simultaneous.

But i have never seen any 8 or 16mb 30p simms only 4mb's, care to take some photos of the ram?

JaNoZ wrote:

They should work, as long as their paired in same size, since the controller does 16bit's to both rams simultaneous.

But i have never seen any 8 or 16mb 30p simms only 4mb's, care to take some photos of the ram?

My bad... I really fucked this plan up, did I? 🤣
Have mistaken 72 for 30 pin mem'. How fucked is that? 😁

JaNoZ, do these qualify? (I was planning to use them for a Goldfinch card I have)

They look awesome, they are from OWC?

Anyone have ever bought some 32MB FPM from OWC that might want to share a picture.
I have to know if they use micron super flat ic's on their ram, they can run ultra low timings at fast FSB at umc.
Or their signal quality excels.

JaNoZ wrote:

they are from OWC?

They're actually from MemoryTen. I know this because I got the original receipt quite by accident - I got this memory along with other PC100 and PC133 DIMMS in a small box, and the receipt was at the bottom folded up. MemoryTen still sells it, but OWC is cheaper; only difference I can see is that this 30-pin SIMM has parity, while the one OWC sells doesn't.