Tried the Wayback Machine? I've had decent luck finding older 3DL drivers both on their site and through board OEMs like Diamond and Symmetric in the past.

Yes. I get to a registration page. Even if I fill in the registration information, I do not get to a valid downloads section of the website. Perhaps you have a direct link?

I have these.

feipoa wrote:

Yes. I get to a registration page. Even if I fill in the registration information, I do not get to a valid downloads section of the website. Perhaps you have a direct link?

The links here seem to all start downloads, but I didn't check every single one:
https://web.archive.org/web/20011202015121/ht … ate_drivers.htm

Try here for Oxygen (you didn't specify which model):
https://web.archive.org/web/20011211204439/ht … ivers/index.htm

Or here:
https://web.archive.org/web/20020124015516/ht … ex.htm#previous

Can go a few years previous, but Permedia3 and the Oxygen series didn't exist then (has Permedia2 and Glint products though):
https://web.archive.org/web/19980421235055/ht … vers/index.html

I was looking for drivers which were a little older. The Permedia3 and Oxygen arrived around Summer of 1999. The oldest archived 3dlabs website which allows for the download of Oxygen and Permedia3 drivers is March 2000, however I cannot get past the "fill out this form before downloading" page.

For example, https://web.archive.org/web/20000309043705/ht … ers/oxygen.html

Yes that form is basically a dead-end because it can never return whatever it needs to return thru the Archive. Why do you need drivers so old?

Also, *which* Oxygen card are you trying to find drivers for? (There is not a singular Oxygen - it's a product line that predates 3DLabs branding).

The ones i attached to my previous post are for Permedia 3 and the Readme is dated 06/17/1999. You might want to try them...